Brand:-
Model:-
MOQ:-0 -
Medical Surgical Fiberglass Polyester Casting Tape For Orthopedic Casting Requires
Product Description :
Orthopedic casting tape is composed by manifold layers of special made fiberglass , which was soaked by polyurethane . Polyurethane material is one kind of block copolymer which contains soft segment and it is characterize by better viscosity , fast drying time , high rigidness and light weight . Dure to better biocompatibility , polyurethane is widely used in medical fields . Animal study and acute and chronic toxicity test have proved that medical polyurethane is non-toxic and no teratogenecity , no local irritation and no anaphylactic reaction .
| Specification | Package | Color |
| 5.0cm x 360cm | 1roll/bag, 10bags/box, 12boxes/ctn | White, Green, Red and Yellow |
| 7.5cm x 360cm | 1roll/bag, 10bags/box, 12boxes/ctn | White, Green, Red and Yellow |
| 10.0cm x 360cm | 1roll/bag, 10bags/box, 12boxes/ctn | White, Green, Red and Yellow |
| 12.5cm x 360cm | 1roll/bag, 10bags/box, 12boxes/ctn | White, Green, Red and Yellow |
| 15.0cm x 360cm | 1roll/bag, 10bags/box, 12boxes/ctn | White, Green, Red and Yellow |
How to use Casting Tape
1) Put the pad (cotton coil or cotton slipcover) on the surgery position .
2) Wear surgical gloves .
3) Select proper specification according to the surgery position .
4) Immerse the roll in room temperature water (21°C - 24°C) for 4 - 6 seconds and squeeze it 2 - 3 times firmly . If the water warmer than 21°C - 24°C shortens the immersing time , while cooler than 21-24°C water lengthens the time .
5) Enwind spirally ; Overlapping the previous layer by one-half or two-thirds of the roll width . To maintain proper tension is very important and take care to avoid excessive tightness . The strength can be determined by the number of layers used . Just 3-4 layers provide a string non-weigh-bearing cast and 5 - 6 layers are typically adequate for weight-bearing cast .
6) Additional after the initial enwinding should be overlapped on itself to achieve good molding . Enwind the roll in 3-5 minutes after immersing in water because after that time it will be concretion .
7) Smooth and rub the surface to achieve good contact between layers . Keeping smoothness helps mold the wrap .
Allow about 10 minutes for sufficient concretion and let patients not move during this time . It could bear electric weight after 20 minutes .
8) It could be windowed , trimmed or removed with traditional cast saw equipment .
Precaution Please apply the surgical rubber gloves when you operate the product.When the resin is stuck to operator , please wipe it out with cotton swab with acetone .
<
