Energy Saving Industrial Gas Generators , Furance Heating Treatment N2 Gas Generator
 
 
Working Principle of 99.99% NitrogenGenerator
Under a certain pressure, using the large difference of the diffusion rate between nitrogen and oxygen
from the air in the carbon molecular sieve, a large number of oxygen is adsorpted by carbon molecular
sieve, while nitrogen is collected in a short time, to achieve separation of oxygen and nitrogen.
The adsorption capacity of carbon molecular sieve is significantly different with different
oxygen pressures, reducing the pressure will release oxygen from carbon molecular sieve, this make
carbon molecular sieve regeneration, then can be used repeatedly.
Using two adsorption towers, one for adsorption and nitrogen generator, the other for desorption and recycling.
They switch with each other, thus continuous output of high-quality nitrogen.
Environment condition of equipment
1. installation place: ground grading, without foundation, but it is necessary to have a sewage discharge
ditch.
2. The reserved area: about 200m2.
3. Ambient temperature: ≤40°C.
4. Relative humidity: ≤80%.
5. Power:440V/ 380V/220V,60/Hz/ 50Hz
 
Specification:

Nitrogen system
1  air compressor
2  Compressed air pretreatment system (dryer and multistage filters)
3  Air buffer tank
4  PSA nitrogen generator
5  Nitrogen gas buffer tank
6  Control system(including man-machine control interface)
7  Instrument and meter (installed in nitrogen generator)
 
2.3  PSA N2 making processing
(1) Inlet air:The air compressor press the air into transporting pipe,then use the compressed air clarification system to remove the water,oil,dust and so on,reach to air buffer tank,then pass through air buffer tank into two adsorption tower.
(2) Adsorption: When air inlet adsorption tower,during the pressure function,O2 and CO2 be adsorbed quickly.Formed N2 near the outlet position.
(3) Air outlet :When the adsorption process working in the best status(Adsorp