Telsmith T-Series Cone Crushers Parts

Basalt crushing configuration

The life of the crusher wear parts is determined according to the hardness of the materials, such as basalt higher than silicon, it is a very hard stone, crusher wear parts requirements are relatively high.

Telsmith T-Series Cone Crushers Parts.Basalt crusher wear relatively large, to consider when buying a good investment costs and pre- and post-production costs, requiring crusher wear parts relatively hard material, the relative price will be high.Telsmith T-Series Cone Crushers Parts.

Telsmith T-Series Cone Crushers Parts.In this configuration the stone, the first due to the use of the broken pyramid scheme (dual-stage jaw broken), if the type of stone grain requirements more stringent, and then later add a back-breaking shaping. Program are as follows:

Feed trough - feeder - rough broken jaw - fine broken jaw - Crusher (plastic machine) - shaker - Finished

Although the use of such programs coarse jaw broken, thin broken jaw, back-breaking three broken, though the number of devices and price of investment more often, but with this fragmentation, the cost of post-production investment is very small,

If manufacturers want to save in the pre-investment funds, the general configuration is:

Feeder - coarse jaw broken - Crusher - shaker.

Telsmith T-Series Cone Crushers Parts

Telsmith T-Series Cone Crushers Parts,This configuration scheme less a fine broken jaw, relatively speaking, cost savings, but to reach the sets of production lines and discharge the same effect, we must increase the pressure on the back-breaking, back-breaking with a double effect, while broken side shaping, namely the large rocks crushed into pebbles, and the pebbles were shaped to produce high-quality stones, the mechanical properties of this stone is relatively strong, while the market price of this stone is relatively high. Will increase the degree of wear of the back-breaking, back-breaking counterattack board material using a high-chromium, the cost is very high. For customers, that is not a small investment. Times more frequent replacement of wearing parts, want to compare with the previous program, although the initial investment is relatively small, but late is a bottomless pit. So the clerk to clients describes how to configure the production line to a lot when a customer's point of view.

visit the website:http://www.hotcrusherparts.com/News/Telsmith-T-Series-Cone-Crushers-Parts.html