SFSP999 Tear Circle Raw Material Hammer Mill Machine

Re: The above indices are those when meeting the following conditions: raw material: corn, moisture content not higher than 14%, density not lower than 0.72t/m3, screen: hole diameter 3mm, hole-opening rate not less than 33%.

The grinding chamber is of tear circle shape, effectively eliminating the circular flow in the grinding process and getting higher capacity;
The Bottom of grinding chamber is fitted with U-shape double grinding structure, further improving the capacity with evener particle size;
Rotor passes accurate dynamic balancing test, resulting in low equipment noise and smooth running.
Both coarse and fine grinding is realized through adjusting the gap between beater and screen;
New type S shape coupling directly connecting driving results in big offset travel and effectively avoid the heating of bearing;
Beater blade edge is vacuum-welded by special alloy steel, resulting in long service life;
The imported products are used for key parts, resulting in long service life and low maintenance cost.;
The moving full-wide operation door facilitates maintenance and replacing of beater;
SFSP999 Tear Circle Hammer Millis widely used in various feed mills, oil plants, alcohol plants, citric acid plants, etc.

Contact Infomation