C Sliding Guide Purlin Roll Forming Machine with Hydraulic station

: Composition of machine

Roll forming main machine……………………………1 unit

Hydraulic Un coiler……………………………………… 1 unit

Punching system…………………………………………1unit

Control panel…………………………………………..1 unit

Hydraulic station…………………………………… …1 unit

Manual out table……………………… ……………….1 unit

Drawing for Profile:

: Details of each composition

A: Roll forming main machine

1: Coil width: adopt profile, and changing size adopts adjusting the ring or spacer

2: working speed: 12-15m/min (not contain cutting and punching)

3: roll station: 15 stations

4: material of roller: GCR15

5:material of main shaft:45steel   diameter roller: 65mm

6: main power: 11 KW motor.   (built in machine)

7: forming thickness: 1.2-2.0mm  250MPa actual yield strength values of coil

8: Transmission: by single Chains 1.5 inch

9: feeding and guide: surface polished and coated with chrome

10: machine adopt new station

11:  Cutting :

Cutting adopts hydraulic cutting

Cutting after forming: Cut the sheet after roll forming to required length

Cutting motion: The main machine automatically stops and the cutting will take place. After the cutting, the main machine will automatically start.

 Length measuring: Automatic length measuring

Tolerance of length: 3m+/- 1.5mm

12.Punching system  

The system is continuous punching ,Not stop punching

The three set of punch molds ( 15x25 )

PLC control punching requirements

Mold material :Cr12Mov

B.  5tons Hydraulic Decoiler  

1. Dimensions: 1700mm*1000mm*800mm
2. Width of feeding: max 1300mm
3. Capability: 5Ton
4. Bound of expand &fight: 450mm—550mm
5. Mode of expand &fight: expand &fight by Hydraulic

C: Control panel Panasonic

(1)   Voltage, Frequency, and Phase: Machine need to accept 380V/3Ph/50Hz

(2)   Automatic length measurement:

(3)   Automatic quantity measurement

(4)   Computer used to control length & quantity. Machine will automatically cut to length and stop when required quantity is achieved

(5)   Length inaccuracy can be amended easily.

(6).  Control panel: Button-type switch and touch screen

(7)   Unit of length: millimeter (switched on the control panel)

D: Hydraulic station

1: hydraulic station power: 5.5kw

2: hydraulic pressure: 20Mpa

E: manual out table:

(1)Jointed by 60mm*40mm tube

(2)Size: 1.0m long*0.8mwide*0.6-1mhigh

(3)One out table with three support rollers

Technological process

De coiling—Punching--—roll forming—-cutting—out table

The external of machine:

Terms of Payment: 30%T/T 70%pay before shipment

Deliver time: 65working days after receive the 30% down payment

Warranty: 1 year warranty from date of shipment