Features:

• Good support for corrections in the cylinder circumference of forme-cylinder and blanket-cylinder
• Changing the printing length
• Paper jam-resistant, crease-resistant
• Self-healing and repositionalble
• Uniform thickness and hardness
• Polyester film with adhesive light (silicon coating) on one side

 Specification:

1270mm*50m/roll(can be cut any specifications)

Thickness:

Application:

• Cleaning the cylinders totally with a wet sponge and washing like alcohol
• If cylinders have a corrosive surface, there could be space where solvents can flow beneath the underlay foil. In this case the adhesion of the foil over a long time can't be guaranteed.
• Putting the sticky side of the foil to the lead edge of the cylinder in a parallel way and pressing it down softly
• Removing and repsitioning the foil to correct place because of the low adhesive at the beginning of contact
• Smoothing out with a dry, fluffy-free cloth from the middle to bothe sides
• Special micro groove structure of the adhesive will help to transfer the air bubbles to the sides and will disappear after a few rotations of the cylinder.
• Removing the foil slowly diagonally flat to the bottom while the cylinder is still warm after 8-10 months of use
• After longer period of use the adhesion increases and the remove will be very hard

Thickness:8C/10C/12C/14C/16C/18C/20C/23C/25C/28C/30C/35C/40C/45C