For Flow Testing: GPM/PSI: 25 @ 5000 RPM:500-5000 for pump testing.
For actuators, valves, and component testing.
Currently MIL-H-5606 fluid service (red oil)Skydrol convertible.

Hyraulic System

Reservoir:

Cylindrical type; steel; capacity 25 U.S. gallons and 3 gallon sump. Equipped with pressurization system to 125 PSI and liquid level sight in-dicator.

Pump:

Nine piston, axial type; mounted on one end of motor shaft with single-direction clutch.

Inlet Circuit:

Pressure actuated switch stops motor and illuminates panel light when pump inlet pressure falls below minimum requirements

Discharge Rate:

15 GPM at 3000 PSIG; 10 GPM at 5000 PSIG.

Fluid Compatibility:skydrol  or...

MIL-H-5606, MIL-H-6083, and MIL-H-83282. Unit may be calibrated for use with other fluids.

Filters:

5-micron, replaceable element type, located in pump suction and return lines.

Relief Valve:

High pressure manual adjustment, 500 to 5000 PSIG with parallel circuited, solenoid-operated, bypass valve, to bypass flow from high pressure system to reservoir.

Heat Exchanger:

Oil-to-water shell and tube type.

Temperature Controller:

Pneumatic, indicating type, panel mounted, and mercury filled system; ad-justable range 100°F to 1800F maintaining ±2°F.

Fluid Cooling:

Diaphragm control valve throttling cooling water to heat exchanger. Con-trolled by temperature controller.

Fluid Heating:

Three immersion type electric heaters installed in reservoir; thermo-statically controlled.

Flowmeters:

Two variable area glass tube type; logarithmic scales. Range: 0.4 to 4 GPM and 2.5 to 25 GPM. Accuracy: ±1% instantaneous reading. Scavenger flow-meter range: 0.15 to 1.5 GPM ±1% instantaneous reading.

Accumulator:

200 cu. in. capacity; working pressure, 5000 PSIG. Nitrogen charged with panel mounted valve and indicating gage.

Foot pump:

Capacity 6000 PSIG static test.

Pneumatic System

Air Motor Pump:

Piston type; minimum pressure ratio 250 to 1. Equipped with air regu-lator; lubricator and air pressure gauge. 20,000 PSI static hydraulic pressure at 80 PSI air input.

Vacuum System

Vacuum Pump:

Tests pump seal conditions to 27 inches mercury vacuum.

Pump Test Pad:

Located on control panel; equipped with adapters to convert to AND2OOO1 and AND20002 pads and splines. Connections provided for air or vacuum.

Torque Indicator:

Indicates pump test pad torque from 0 to 1000 inch-pounds in either di-rection of rotation. Indicated on direct reading scale on unit control panel.

Variable Speed Drive

Horsepower:

30 HP continuous rating; 40 HP, 1 hour; 50 HP, 3 minutes.

Range:

750 to 5000 rpm-manual hand wheel adjustments.

Speed Indicator:

Range 0-5000 rpm. Over-all accuracy ±2%

Power Requirements:

440-volt, 3-phase, 60-cycle. Draw approximately 45 KVA. 115-volt, single-phase, 60-cycle, 100 watts.(please advise if power requirements are different)

Additional External Connection Requirements

Air-90-125 PSIG shop air system; Water-15-20 GPM at 700F.

Special Features:

Fluorescent panel lighting; back-lighted flowmeters; synchronous electric clock and timer, frequency regulated from 115-volt, 60-cycle, a-c power supply.