DIRECTIONS FOR JACK

1. Put jack on the flat ground under the lifting point of the tire for replacement, first adjust the height of manual screw on the jack properly to ensure the jack can be lifted safely and effectively.

2. Put the pad on the top of the jack horizontally and upward(used for contacting the chassis of the vehicle). In the course of lifting, vehicle should be vertical with the jack, operation with jack inclined is forbidden.

3. Connect the jack to 12V power source with the following two methods:
(1)Connect with a cigar-lighter: Insert one end of the attached power cord into the socket of the cigar-lighter, and the other end into the power cord(Caution: Rated current of fuse of the cigar-lighter should not be less than 15A. )
(2)Direct connection with battery of the vehicle(recommended to use): When current of fuse in the cigar-lighter is less than 15A, insert plug on power cord for the cigar-lighter into attached part of power cord with holders, and clamp positive pole "+"of the battery with the red holder and negative pole"-"with black holder.
(3)Operation: After the above operations are confirmed OK, start the operation of lifting ("UP"is for ascending, and "DOWN"for descending. )
(4)In the course of lifting, lifting conditions should be watched carefully. And lifting should be stopped after the wheel is 20mm from the ground and wheel can move round freely. Then turn the switch to the middle position for replacement of tires.