Clamp set items in case of
changes in product specification

Required:
Different pressure settings depending on products
to prevent deformation and movement

Not required:
As a toggle clamping type, it prevents plastic
deformation, implementing strong clamping
without changing pressure even if products vary

Required:
The center of the fixed jaw needs to be reset
according to the changes in the product
diameter because they are clamped with one
jaw fixed.

Not required:
Products are clamped on both sides through
toggle clamping system, which makes processing
possible with no need for resetting.

Jaw
replacement

Right and left slide adjustment is made by driving one servo motor,
resulting in considerable material loss when cutting.
(frequent loss of materials)

Individual adjustment of the right and left slide is made
by driving 2 servo motors.(prevents material loss)

Possible to set backward motion (individual backward
motion/simultaneous backward motion) according to
different machining demands of each end of the pipe

2. Automatic length inspection device

Reduced setting due to changes in
product dimensions

Enhances dimensional accuracy (Cpk)
through automatic calibration of the
value measured in the length inspection device

Minimal eccentric machining due to
chips through bottom-up product
supply system

Stops when defective products are
found consecutively
(Stops automatically when the set
number is exceeded)

Maintains the constant product length
through automatic calibration of the
amount of tip wear