Product Description
Acrylic is a one-component, elasto-plastic sealing putty based on acrylic aqueous dispersion, which is designed for joints between construction parts exposed to low stresses.
Acrylic is ready to use and gives excellent performances both in inside and outside situations, showing good adhesion on porous surfaces such as concrete, plaster, asbestos, brickwork, cement, wood. Not recommended for joints in continous contact with water.

Composition: Acrylic basis
Consistency: Pasty
Packing: 280ml / cartridge
Printability: Acrylic can be painted in almost any kind of paint.
 
Typical Values

Specific weight: (1.60 +/- 0.05) g/cm3
Skin over time: 10 to 20 minutes
Curing time: 1-4 weeks according to joint thickness, temperature and air humidity
 
Characteristic after hardening

Volume variation: (-12 +/- 2) %
E-module 100%: (0.31 +/- 0.02) N / mm2
Joint movement capability in services: 6% of joint width
Service temperature: - 25 degree Celsius to + 80degree Celsius

Application

Surface Preparation: Surface must be clean from dust, oil, grease, bitumen and ice. Minimum joint width 6 * 6 mm / max. 25 * 20 mm.
Use diluted Acrylic (at brushable consistency), as a primer for high porous surfaces.
Acrylic will show good adhesion even on wet surfaces.
Application temperature: + 5 degree Celsius to + 50degree Celsius
Shelf Life KTR600Up to 12 months / store cool and dry / protected from freezing and heat.
Warning: Don't apply in case or imminent danger of rain. Protect from rain for at least 6 hours after application.