1.Function Parameter Guide
1) Input electricity - AC220V/50Hz
2) Voltage - DC5V
3) Power - 15W
4) Cleaning Frequency - 8KHz
5) Max.Setting time - 15minutes

2.Application
This product are make for piezo printhead cleaning processing,usually it can be clean in a few minute and back to work again likeusual before it was.To make period of cleaning process to printhead is very important, because this can make the life of printhead much longer, and decrease the waste clog time, and to accordthe low cost.
Every kind of large or small format plotter.Now it is adapt forXAAR, SEIKO, SPECTRA, KONIKA, EPSON etc.

3.User Guide
1) In the power off situation connect the print head and print headcleaner with the connector(Notice the print head connector andprint head cleaner have to put in the correctly position)
2) Use glass syringe to inhale the cleaning fluid and use theprovided oil tube to connect the inlet of print head and put intothe container
3) The cleaning fluid id 4-5cm deep in container(the front part ofprint head have to be inside of the cleaning fluid)
4) Turn on the power of print head cleaner(in the meantime you canhear a little noise) then push the syringe slowly and carefully
5) In this time you have to check the clean situation of cleaningfluid,if you have found dirty or something, you have to change thecleaning fluid and then clean the print head again till the printhead are all unclog
6) Cut the power off, and disconnect the connector