Brand:rb
MOQ:2000
Quantity:100
Send Inquiry
Flexible work glove
1.Synthetic leather Palm(0.75-0.8mm)
2.Spandex Back
3.Spandex finger
4.Elastic cuff
Flexible work gloveModel Number:rb110032Feature: Stretch fabricback for flexibility and fit.Synthetic leather palm .Spandex Backwith neoprene for protectionSpandex finger is forflexibility.Elastic cuff keep debris out.Wing closing strap forperfect adjustments and
easy-on, easy-off.Pakage:A plastic bag per pair,120pairs percarton(58*28*45)Quantity/20FCL:4500dozensPayment term:T/T(30%inadvance,70%aftshipment)Application: Automotive/Oilindustry/Mechanic/Heavy machine/Household about your LOGO wecan doPVC Label and Silicon print Embroidery Digitalheat transfer CEstandardEN 388Gloves giving protection from mechanical risksProtection against mechanical hazards is expressed by a pictogram followed by
four numbers (performance levels), each representing test performance against a specific hazard. 1 Resistance to abrasion
based on the number of cycles required to abrade through the sample glove (abrasion by sandpaper under a stipulated pressure). The protection factor is then indicated on a scale from 1 to 4 depending on how many revolutions are required to make a hole in the material. The higher the number, the better the glove. See table below. 2 Blade cut resistance
based on the number of cycles required to cut through the sample at a constant speed. The protection factor is then indicated on a scale from 1 to 4. 3 Tear resistance
based on the amount of force required to tear the sample.
The protection factor is then indicated on a scale from 1 to 4. 4 Puncture resistance
based on the amount of force required to pierce the sample with a standard sized point. The protection factor is then indicated on a scale from 1 to 4.If some of the results are markt with a X means that this test performance is not tested. If some of the results are markt with a O means that the glove did not pass the test. TestPerformance level 12345Abrasion resistance (cycles)10050020008000 Blade cut resistance (factor)1,22,551020Tear resistance (newton)10255075 Puncture resistance (newton)2060100150 EN 420This standard defines the general requirements for protective gloves in terms of construction, fitness of purpose, safety, etc· The gloves themselves should not impose a risk or cause injury.· The pH of the gloves should be as close as possible to neutral.· Leather gloves should have a pH value between 3.5 – 9.5.· The
