Spray Adjuvant
Lionsi™ CN-280
Organosilocone Surfactant
Active Ingredients:
Polyalkyleneoxide modified heptamethyltrisiloxane-----100.0%
Cas Number: 67674-67-3
Product Overview
Lionsi™ CN-280 is a 100% organosilicone formulation designed to reduce surface tension, it is a non-ionic spreading and a penetration aid. once added to the spray, it considerably lowers the surface tension of the water so that the sprayed drops adhere better on the plant surface. At the same time, this additive causes an effect known as "super spreading", a process whereby sprayed drops are distributed widely and rapidly, resulting in an evenly wetted plant. Moreover, Lionsi™ CN-280 improves the absorption into the plants tissue of plant-protecting active ingredients. So Lionsi™ CN-280 helps to optimize plant protection measures.
Features & Benefits
Maximum spray coverage of large target plants and waxy leaf surfaces
Faster drying on the leaf surface
Low use rates at high water volumes
Increases foliar micronutrient uptake
Nonionic
Typical Properties
Physical appearance-------------------Clear, light amber liquid
Specific gravity----------------------------1.0 ~ 1.02
PH(1.0%) -----------------------------------6.0 ~ 7.0
Surface Tension(0.125%v/v)-----------20 ~ 22 dynes/cm
Flash point(close cup)------------------->110
Viscosity at 25 ------------------------25~80cSt
Contact Angle(0.125%v/v)----------------0 ~ 4 degrees F
USE
Directions For Use
Lionsi™ CN-280 surfactant has been found to be effective in agricultural applications at 0.025 to 0.25% v/v concentration. Some applications may require lower or higher surfactant rates for optimum effect. Do not add adjuvant at a level that would exceed 5% of the finished spray volume/ When this occurs, adjust rates to obtain thorough coverage without excessive runoff. Diminished performance will result it tank mix pH is excessively high(above 9) or low(below 5). Optimum performance of Lionsi™ CN-280 will result between pH of and 8. Prior to use of Lionsi™ CN-280 in any agricultural application, the user, applicator or advisor must experience or must have conducted a phytotoxicity trial on the crop to which the application is to be applied.
Mixing
Prior to any pesticide application all spray mixing and application equipment must be thoroughly cleaned. Carefully observe all cleaning directions on the pesticide label.
1. To prevent of minimize foaming, fill tank to 2/3 to 3/4 full of water. If foaming is anticipated, the addition of an antifoaming agent should be added before pesticides, nutrients, or Lionsi™ CN-280 is added.
2. Add pesticides and /or fertilizers ad directed by label or in the following sequence:
A. Micronutrients and fertilizers
B. Dry flowables and dispersible granules
C. Flowables
D. Water soluble pesticides
E. Emulsifiable concentrates
3. Continue agitation
4. Add Lionsi™ CN-280 and mix for 1 to 2 mixing with lower than normal agitation.
5. Continue filling tank, maintaining minimal agitation.
6. For optimum results, spray mixes containing Lionsi™ CN-280 should be applied within 36 hours after mixing.
Packaging:
Steel drum with bung 180 kg
Plastic pail 25 kg
Storage and disposal
Do not contaminate water, food or feed by storage and disposal. Store in original container only. Keep container tightly closed, do not allow water to be introduced into cleaning of equipment, disposal of equipment wash waters of spray waste. Do not store near open flame.
