Description:
1. High wear &corrosion &abrasive resistance.2.Advanced equipment, HIP sintering.
3.10 years production experience.
Our nozzlesare built to speed the flow of gases, liquids and slurries ofvirtually any viscosity and to withstandpunishing wear, erosion and/or chemical attack in harsh chemicaland powder service environments. They have proved to be a highperformance, long-lasting alternative to hardsteel.
For nozzles,tungsten Carbide nozzle is the most rugged and durable and providesthe best value.
A nozzle isa device designed to control the direction or characteristics of aflow (especially to increase velocity) as it exits (or enters) anenclosed chamber or pipe via an orifice. For nozzles, tungstenCarbide nozzle is the most rugged and durable and provides the bestvalue.
Tungstencarbide nozzle is made by the precision machining with the tungstencarbide materials (superhard alloy). The hardness reached overHRA90 degree while the anti-bending degree reached over 2300N/mm2.On machining tungsten carbide nozzle, we do the precision grindingand surface treatment to achieve Ra0.1 of the bore roughness andthe Ra0.025 of the R place of both ends. There is a scientificcurvature radius design in the both entrance. This design canensure a smooth transit of the thread. Due to the overall materialsprocessing, and no elevation in the bore, the phenomenon ofeasy-bending and plugging has been improved comparing with the rubynozzle.
Tungstencarbide nozzle is made from hot pressing with straight bore andventuri bore type. Due to its hardness, low density and excellentwear and anti-corrosion, Tungsten carbide nozzle has been widelyused in sandblasting and shot peening equipment, offering a longlife with optimum air and abrasive use.
How tochoose a tungsten carbide nozzle?
Whenchoosing a tungsten carbide nozzle, consider the amount ofavailable air in cfm, the capacity of the blast machine and theinside diameter of the piping, and the blast and air hoses. Foroptimal performance, these elements must be compatiblysized.
If too largea nozzle is used, low blast pressure and rapid wear on the blasthose will occur. If too small a nozzle is used, smooth media flowwill be difficult to achieve.
