Description:
By Computer Aided Design (CAD) clamping system, the clamp strokeand distance between tie bars have been enlarged for versatileHD-USVSeries Servo Power-Saving Thermosetting Injection MoldingMachine HD-100USV~160USV
Clamping Unit
1.By Computer Aided Design (CAD) clamping system, the clamp strokeand distance between tie bars have been enlarged for versatileusage.
2.Machines are equipped with up-down togglesystem for high speed molding.
3.Linear potentiometer can reach 0.01mmhigh accuracy, and all position settings can be saved into thecomputer, suitable for high precision molding.
4.Fully automatic lubrication device ensuresexcellent lubricating effect and assures machine''saccuracy.
5.Ring gear and hydraulic motor driving are forquick die height adjustment.
6.Hydraulic ejector is time retaining,vibration, position retain functions, and an air blasting ejectorcan be added.
7.Core pull and unscrewing device havemulti-sequence design, suitable for all kinds of molds.
8.Installed with sliding clamp system cover, easy for inspectionand maintenance.
InjectionUnit
Suitable for thermosettingplastic material, double-function for exchanging betweenthermo-plastic and thermosetting.
1.By linear potentiometer for0.01mm high precision position control for injection and clampingsystems.
2.Use of oil heatingcirculation and electric heating for barrel, ensures the stabilityof temperature control.
3.Specialized screw & barrel for thermosetting, special treatedsteel of barrel set for anti-erosion when in use of thermosettingmaterial.
4.Built-in cold startprotection, loop break alarm and heat reservation function, thetolerance of temperature deviation is ±1°C only.
5.High torque andexcellent performance of hydraulic motor can drive screw directlyand shorten plasticizing time so that saves energy.
6.Bad product detecting functionto recognize short-shot or other unnormal products
7.Special design of nozzle forquick-clearing purpose when machines suspended.
ElectricalUnit
1.Electrical, hydraulicand mechanical safety devices consist tri-interlock safetysystem.
2.Emergency stop onoperation & rear sides.
3.Low pressure mold opening& closing protection.
4.Hydraulic overheatingalarm & automatic shut-down devices.
5.By microprocessor controller equipped with 4 stages injection, 3stages holding pressure and 3 stages back pressure.
6.Shut-down memorized devicewith 100 memory presets on molding data.
7.EL display of pressure, speedtime and distance for each motion.
8.Screw rotating speedread-out.
